Parameters of FPMCPU and repeater

The “Logic” section of FPMCPU module programming provides all the parameters and programming options of the module itself.

 

• Label – 20 character string that identifies the control panel or repeater

• Cluster / Reference control panel – referring to the repeater being programmed

• Instant alarm on second pre-alarm – option that, if activated, generates an alarm signal as soon as two detectors, regardless of the zone they belong to, go into pre-alarm status.
  



• Evacuation button function – field to indicate the function activated when pressing the “Evacuation” button.

  • Evacuation can only be activated by access level 2
  • End Pre-alarm

• Groups activated in evacuation – selectable via the dedicated button



• Mute buzzer – option for muting the module buzzer
  
  



• Do not unmute on new alarm – option that, if activated, does not undo muting when a second alarm occurs

• Unmute sounders after – field where you can indicate the time in seconds after which muting will deactivate after having been activated, only when the control panel is operating in “night” mode

• Stop pre-alarm countdown if sounders muted – option that, if activated, interrupts the pre-alarm time in the case of muting

• Undo muting on gas alarm – option that, if activated, will undo muting when a gas alarm occurs



• Lockout rearm after extinction – field where you can indicate in minutes the delay after an extinction operation during which a rearm operation will not be possible

  After reset time – field where you can indicate in seconds:

  • the duration of activation of outputs programmed as “Active after reset”

  • the waiting time for evaluation of contributions for shared groups on the network, time during which signals from each of the shared groups will not be considered valid

• Panel time keeper – option that, if activated, allows the control panel to send its own time once a day to the Hornet network and to overwrite that of the other control panels

• Disable user level groups – checkbox for the lowest user level that is allowed to manually disable output groups

• Manual activation of user-level groups – checkbox for the lowest user level that is allowed to manually disable output groups

• Remote rearm not accepted – option that allows remote rearm operations



• MODBUS addresses – button that opens a window where you can select the MODBUS address of the control panels in the Hornet network

• MODBUS TCP disabled – option that, if activated, disables the MODBUS protocol over TCP-IP

When programming repeater modules in a system with voice emergency functions, the button on the top button bar also provides access to the management of FPAMIAS panels present in the Hornet+ and IDANet network.

The section you access allows you to set up functions of the voice emergency system that can be reproduced on the fire system.

• Manage audio zones – if this option is deactivated, the entire section currently being programmed will be ignored by the control panel.

• Rearm fire control panel from – if this option is activated, rearming from a repeater also effects the FPAMIAS panel, and therefore the entire control panel.

• Mute control panel – if this option is activated, muting from a repeater also effects on the FPAMIAS panel, and therefore the entire control panel.