Air2-FD100
Two-way wireless smoke detector for Inim systems
The Air2-FD100 smoke detector allows you to add advanced smoke-detection capabilities to the SmartLiving control panel. This device greatly enhances the capacity of any home security system.
Air2-FD100 provides unique features. In fact, it can verify the level of contamination (dust) inside the optical chamber and signal the need for cleaning. The analogue values regarding the level of contamination in the optical chamber are shown on the keypad.
The state-of-the-art detection technology used in the Air2-FD100 is typical of the technologydriven environment of INIM’s entire range of fire detection devices. This technology provides you with 4 programmable levels of smoke-detection sensitivity (0.08dB/m to 0.15dB/m). The Air2-FD100 is equipped with a tricolour LED (green, yellow and red) which signals the normal operating status of the device, low battery status, contamination in the optical chamber, alarm and fault conditions. This device provides an option which disables the visual signals on the LED.
You can configure all the device parameters via the wireless network without the need for direct intervention on the device itself.
Frequently security professionals perceive the market need for a reliable, truly proficient wireless system. And now, thanks to INIM’s perception of installer company needs, that system is available.
The first-rate “Air2” wireless system operates over 868MHz band and moreover uses two-way signal transmission technology. This means that all the system devices transmit and receive signals. This two-way transmission technology also means that the traditional receiver has been replaced by a superior device that not only receives but also transmits signals to all the system devices.
Therefore, the “Air2” system does not rely on one-way alarm signal transmission, like most wireless systems, but verifies the successful effect of the signal on the target device via a two-way wireless transmission channel. Security professionals will find the innovative operating principles and superior functions of the “Air2” wireless system more than convincing and will surely appreciate the advanced features of the system diagnostics.
The transceiver connects directly to the control panel I-BUS (INIM’s peripheral communication bus) and allows fully-integrated management of all wireless and hard-wired devices. INIM’s “Air2” high-performance wireless system provides complete protection and in no way lowers security. Choosing “Air2” means reducing installation time to a minimum whilst at the same providing those hard-to-get-to spots with total protection. The “Air2” wireless system can be installed without defacing the structure it protects, and therefore finds its niche in buildings of importance such as churches and museums where extensive structural work would spoil the overall appearance of the building.
AIR2-FD100 smoke-detector features | |
Communicates with the Air2-BS200 |
Two-way transceiver |
Protected against dislodgementa |
From its base |
4 programmable levels of sensitivity |
0,10dB/m (pre-set mode); 0,10dB/m; 0,10dB/m; 0,10 dB/m |
Tricolour signalling LED |
Normal operating status, fault, contamination in the optical chamber, low battery, alarm |
Option |
To disable LED signalling |
Battery |
CR17450 |
Battery life |
3 year |
Dimensions (HxDxW) |
60x114mm (with base) |
Weight |
160g (with base and without battery), 182g (with base and battery) |
Technical features of the system |
|
Operating frequency |
868MHz |
Communication type |
Two-way |
Modulation |
GFSK |
Channel |
3 |
Air2-FD100 - Asennus- ja ohjelmointioppaasta (Finnish) (File PDF - 456 Kb)
